■  Piping Material Take-Off (MTO)

• Preparation of 1st material take-off sketch and excel data generated from P&ID and plot plan
• Preparation of 2nd material take-off sketch and excel data generated from piping layout
• Preparation of final material take-off based on isometric piping drawings
• Preparation of additional material requisition based on addendum

■  Piping Layout

• Preparation of conceptual design
• Preparation of design under study phase
• Preparation of final or detailed design
• Fabrication of plan drawings and isometric drawings

■  Piping Support

• Selection and design of pipe support from standard
• Preparation of special support drawings including summary of materials

■  Piping Information to all disciplines

• Preparation of general information
• Preparation of civil and structure information
• Preparation of sleeper information
• Calculation of piping loads

■  Stress Analysis

• Selection of critical lines for stress analysis
• Preparation and evaluation of stress calculation drawings
• Preparation of line conditions of stress analyzed lines

■  Steam Tracing

• Preparation of steam tracing assembly
• Arrangement of steam tracing manifold on layout
• Preparation of distribution and collection manifold list
• Layout of distribution and collection manifold headers and piping

■  3D Modeling

• 3D modeling using PDS, PDMS, SP3D and AP3D
• 3D model review and interface check using Navisworks and SPR
• Fabrication of extracted  isometric drawings